Channel Settings - Sony MB-8N Operating Instructions Manual

Settings

Channel Settings

When making the channel settings, consult the Frequency
Lists on the supplied CD-ROM.
When using two or more WRU-8N units
simultaneously, to avoid interference or noise, set the
WRU-8N units as follows.
• Same group other than "00" and groups of 25-kHz
steps.
• Different channels.
A RF B AF
GP CH
WRU-8N
1
Press the power switch, powering on the unit.
The MB-8N display shows a "Welcome" message,
then displays the menu (Local or Remote menu)
for the currently selected mode.
Note
Powering on may cause noise in audio output, so
before operating the power switch turn down the
inputs of the connected devices.
2
If the MB-8N display shows "***Remote
Menu***," hold down the LOCAL/REMOTE
selector button for three seconds.
The display then shows "***Local Menu***," and
the unit is in local mode.
Note
It is not possible to make channel settings in
remote mode. (It is, however, possible to select the
group/channel or frequency indication using the
DSPL button.)
In remote mode, the jog dial has a separate function.
For details see page 30.
30
TX BATT
DSPL
6-1
3,4,5,6,7
3
Press the jog dial.
The group indication flashes.
4
Turn the jog dial clockwise (+) or
counterclockwise (–), to select the group.
Each time you turn the jog dial clockwise (+) or
counterclockwise (–), the group indication changes
in the sequence shown in the following figure.
Holding the jog dial in the turned position makes
the display change continuously.
The display differs with models of WRU-8N.
CE62
GP CH
CE67
GP CH
U6264
GP CH
U6668
GP CH
AU66
GP CH
GP CH
GP CH
GP CH
GP CH
GP CH