Rear Panel - Sony MB-8N Operating Instructions Manual

Rear panel

1 ANTENNA A, B IN/DC 9V OUT
connectors
2 ANTENNA A, B OUT connectors
IN OUT
ANTENNA B
1 ANTENNA A, B IN/DC 9V OUT (9V DC
output) connectors (BNC type)
Connect an optional AN-820A or similar UHF antenna
to each of these.
When an AN-820A is connected, this connector
supplies 9V DC power to the booster incorporated in
the antenna. When using an antenna which does not
require a power supply, you can switch the power
output off.
For details of the 9V DC power supply, see "Voltage output
to an antenna" (page 27).
Note
Do not short-circuit this connector.
2 ANTENNA A, B OUT connectors (BNC type)
These output the signals input to the ANTENNA IN
connectors. Using these connectors, you can connect
up to four of these units in cascade.
When using a cascade connection, set the RF
attenuator for the MB-8N units to which no antenna is
directly connected to "OFF."
For details of cascade connection, see "Cascade
Connection" (page 18).
For details of the antenna RF attenuator setting, see
"Antenna RF attenuator" (page 27).
4 3 2 1
IN OUT
AUDIO OUT ANTENNA B
7 AUDIO OUT connectors
3 SUB AUDIO OUT connector
4 10BASE-T connector
5 DC IN connector
SUB AUDIO OUT 10 BASE T
~ DC IN
3 SUB AUDIO OUT connector (D-Sub 15-pin)
This outputs the audio signals from each WRU-8N
unit.
Note
Be careful not to mistakenly connect this connector to
the computer monitor.
For details of the SUB AUDIO OUT connector pin
assignment, see "Connector Specifications" (page 33).
4 10BASE-T connector (RJ-45 type)
This is a 10BASE-T connector for network
connection.
Connect to a Windows computer, in order to use the
supplied MB-8N Network Controller software for
communications with the computer.
For connection to a computer, use a category 5 LAN
cable with a maximum length of 100 m (330 ft). If the
connection requires a total cable length exceeding
100 m (330 ft), use a hub between the computer and
this unit.
Use the following type of cable when:
Directly connecting the computer and this unit:
cross cable
Using a hub between the computer and this unit:
straight cable
Caution
Only connect 10BASE-T cables to the
network) port. Do not connect any other type of
network cable or any telephone line. Connecting
cables other than those listed above may result in an
electric current overload and could cause a
malfunction, excessive heat, or fire in the connector.
To connect the unit to the network, contact your
network manager.
6 AC IN connector
(Ethernet
13