Settings; Wireless Channel Selection - Sony WRR-805A Operating Instructions Manual

Settings

Wireless Channel Selection

RF TX BATT
RF AF
2
GP
1
Note
Noise may occur when the power is turned on or off. Be
sure to turn down the input level of the connected equipment
before operating the POWER switch.
1
Set the POWER switch to ON.
The display shows the same status as before the tuner was
last turned off.
If the group name and channel number is shown on the
display, skip step and proceed with step
2
12
3 , 5, 7
BATT
CH
4, 6
.
3
2
Press the MODE button until the group name and channel
number appear on the display.
3
Press the SET button.
The tuner enters in group selection mode and the group
name flashes on the GP section.
In group selection mode
4
Press the + or – button to select the group.
Pressing the + button cyclically changes the group
indication in the order of "Wireless Channels Selectable"
on page 5 to 7.
Pressing the – button changes it in the reversed order.
If you hold either button pressed, the group setting will
change continuously.