Installing and Removing a WRU-8N
You can install up to four WRU-8N units in this unit.
Notes
• Be sure to power this unit off first.
• Pressing too strongly on the jog dial or indicaters on
the WRU-8N front panel may damage it. Always
press on the edges of the front panel.
• Do not touch the WRU-8N rear panel and connectors.
• Be careful of static electricity.
Installation
1
Press the upper and lower tabs of the blanking
panel, and pull the lower edge forward, to remove
the blanking panel.
2
Holding the sides of the WRU-8N, insert it in the
slot, and press in until the panel is flush with the
MB-8N operating panel.
16
3
Turn the fixing screws, to fix.
Removal
1
Fully loosen the fixing screws.
2
Holding the fixing screws in both hands, slowly
pull out.