Wru-8N Tuner Unit (Option) - Sony MB-8N Operating Instructions Manual

Location of Parts and Controls
5 DC IN connector (XLR type)
Use this when operating the unit with a DC power
supply. The voltage range that can be used is +12 to
+24 V.
Note
When power is supplied through this connector, the
front panel power switch no longer controls the power
to this unit. Be sure to use a DC power supply with a
power switch, which you can use to power this unit on
and off.
For details of the DC IN connector pin assignment, see
"Connector Specifications" (page 33).

WRU-8N Tuner Unit (Option)

1 WRU-8N display (see next page)
MENU
A RF
ENTER
LOCAL
1 Fixing screws
1 Fixing screws
These fix the WRU-8N unit to the MB-8N unit (this
unit).
2 Jog dial
The jog dial has two functions, as follows.
• Press to set the setting changing mode, or to confirm
a setting (corresponds to the function of the ENTER
button).
• Turn clockwise or counterclockwise to change a
setting (corresponds to the function of the +/–
buttons).
14
1 2
B AF TX BATT
DSPL
GP CH
WRU-8N
3 DSPL button
2 Jog dial
6 AC IN connector
Connect to an AC power source with the supplied AC
power cord.
7 AUDIO OUT connectors (XLR type)
These output the audio signals from corresponding
WRU-8N units. Connect to the audio input connectors
of a mixer, amplifier, or other equipment. You can set
the output level for each WRU-8N unit separately.
For details of the output settings, see "Audio output levels"
(page 27).
For details of the pin assignment of the AUDIO OUT
connector, see the section "Connector Specifications" (page
33).
In local mode, use this to change a group (GP),
channel (CH), or frequency setting.
When pressed, the display flashes, and the setting can
now be changed. In this state, turning clockwise or
counterclockwise changes the setting, and pressing
once more confirms the change. In the group/channel
(GP/CH) display, repeat this operation to set both the
group (GP) and channel (CH).
In remote mode, by pressing the jog dial you can
monitor only the audio of the WRU-8N unit with the
headphone connected to the PHONES connector (solo
function).
3 DSPL (display) button
Pressing this button toggles the WRU-8N display (next
page) between the group/channel (GP/CH) display and
frequency display.