Rear Panel; Operation - Sony WRR-800A Service Manual

Uhf synthesized diversity tuner
Table of Contents

Advertisement

Rear Panel

1 TUNER OUTPUT (tuner sound output) connector
(ø6.3 phone balanced (
1
/
inch TRS))
4
Supplies audio signals. You can connect this to the audio
input connector of a mixer, amplifier, or similar equipment.
2 DC IN 9V (9 V DC power input) connector
Connect the supplied AC power adaptor.

Operation

1
ANTENNA A, B
3
2
4
5
+
UHF
UHF synthesized
synthesized
transmitter
wireless
microphone
1
Connect the supplied antennas and make the antenna
tips point upward.
2
Connect the supplied AC power adaptor to the DC IN
9V connector and an audio mixer or amplifier to the
TUNER OUTPUT connector.
12
1-6
LINE LEVEL 0dBm
TUNER OUTPUT
1 TUNER OUTPUT connector
2 DC IN 9V connector
3 Cord clamp
3 Cord clamp
Attaches the cord of the AC power adaptor.
3
4
DC IN 9V
AC power adaptor
5
TUNER OUTPUT
Audio mixer, amplifier
If noise is heard
Depending on the environment where the system is
installed, outside noise or radio wave may disrupt the
transmission of certain channels.
To select a channel under this circumstance, turn off the
wireless microphone or transmitter. Then select a channel at
which the RF indicator is off. (A channel free from noise or
radio wave interference is selected.) Set the same channel on
the microphone or transmitter.
DC IN 9V
¥
Turn the POWER switch on.
Note
Turn the POWER switch on after reducing the volume
of the equipment connected to the TUNER OUTPUT
connector. Otherwise, noise will be heard when the
POWER switch is turned on.
Set the reception channel.
For details on setting the channels, see page 13.
Turn on the wireless microphone or transmitter.
Use the wireless microphone or transmitter to which the
same channel is assigned as to this unit.
11
WRR-800A(AU)

Advertisement

Table of Contents
loading

Table of Contents