CBE PC-540HY Instruction Manual page 31

BURGLAR FUNCTIONS (OPTIONAL)
TIMED AWNING LIGHT (OPTIONAL)
An electronic device enables the timed switching of awning light by pressing button 5 of the remote
control; the light will remain switched on for the period of time set on the PC-540HY control board
(see USER SETTING).
OPEN DOORS OR PEAKS ANOMALIES
The anomaly is signalled with open doors or peaks and with the ignition key inserted (+ key).
Anomaly messages are:
- « L/H LKR OPEN
- « R/H-BK LKR OPEN
- « DOOR OPEN
ANOMALIES CHECK
When activated, the device checks possible anomalies of closing systems and of the volumetric
sensor. These anomalies are signalled with 5 short flashings of the indicators.
REMOTE CONTROL ACTIVATION
Go to the « MANUFACTURER SETTING » on the PC-540HY control board, menu CONFIG.
ALARM N+B/REMOTE CONTROL/ACTIVATION and select
times button 2 of the remote control. When the button is pressed for the third time the flashing of the
indicators indicates that the remote control has been accepted.
REMOTE CONTROL RESET
This function enables to reset all remote controls (see MANUFACTURER SETTING)
After the resetting, remote controls shall be reactivated (see REMOTE CONTROL ACTIVATION).
TELEPHONE NUMBER SETTING
Enter « User setting » in the PC-540HY control board, menu
NUMBER and set the digit with button 5 and confirm the entry by pressing PROG. button no. 4.
NOTE: in compliance with existing regulations, the device sends the alarm for a maximum of 10
times; the deactivation of the device resets the count of interventions.
» when the left peak is open.
» when the right and/or rear peak are open.
» when the cab's and/or van's door are open.
« ON ». Press shortly for 3 consecutive
« CONFIG » BURGLAR ALARM/TEL.
31