"Pc-540Hy " Control Panel - CBE PC-540HY Instruction Manual

1
4
1)
On/off general switch (to turn on press for 2 seconds):
a short pressure turns between "ON" and "STAND BY";
a two sec pressure turns completely off the system.
-"ON" mode: complete system's and user's operation (LED indicates the operation of every
user).
-"STAND BY" mode: heating, anti ice, gas valve and gas detector operation.
In this mode the user's buttons are disabled excepting those related to the heating system,
which remain in the "ON" mode.
User's LED are disabled and substituted by a sign appearing on the LCD (all alarms are
disabled, excepting gas detector and gas reserve.
2)
Button for control of car and leisure batteries voltage (in Volt) and load and recharge current (in
Ampere) for the leisure battery (see also "AMPMETER" function).
3)
Button for control of drink, recovery and waste water tank (in "%") and for drink water refilling function
operation (see "DRINK FILLING" function ).
4)
"PROG" button for system's programming (see SETTING).
5)
Buttons for programmable parameters' setting (see SETTING).
6)
Button to switch the pump on and off (see "PUMP BLK" function).
7)
Control button for engine heating exchanger.
8)
Button to switch on the anti-ice resistor "Eis-ex".
9)
Gas valve control button; the commutation start/low consumption is controlled automatically by the
microprocessor. Gas valve is automatically closed by gas leakage alarm.
10)
Volumetrical alarm on/off button; this function is operating also when the control panel is switched off.
11)
Gas detector on/off button;
NB: - During a test function (batteries ref. 02 and tanks ref.03) it is possible to maintain the
visualisation for one minute by pressing the "PROG" button (ref.)
- To cancel an alarm signalling, press one of the buttons

"PC-540HY " CONTROL PANEL

2
Flair
3
5
PC-540HY
gas valve must be operating
6
9
.
ref. 05.
56
25
7 8
Motor
10 11