Airstream classic 2006 Owner's Manual page 78

ELECTRICAL
SATELLITE ANTENNA WIRING
If you compare the two previous drawings you'll see wiring
for a satellite dish antenna is relatively simple.
Units have a faceplate with two coax cable hook-ups. The
faceplate has a small coax cable jumper running between
the hook-ups to complete the cable TV circuit when in use.
To install a satellite system use the following procedure:
1. Remove the jumper wire from the
coax faceplate.
2. Hook a portable dish into the
Cable TV receptacle in the roadside
rear underbelly compartment. This
feeds the dish signal to the input side
G
of the faceplate.
3. Install the satellite receiver input
and output into the dual coax
faceplate.
To return to a cable TV system, remove the satellite receiver
from the faceplate and reinstall the jumper cable.
G - 11