Airstream classic 2006 Owner's Manual page 47

Draperies
CAUTION
: All drapery materials and mattress
covers must be professionally dry-cleaned.
Unsnapping from the wall, removing a screw or pop
rivet from the end of the curtain track, and sliding them
out remove draperies. The pop rivets are removed by
drilling through the head with a 1/8" drill bit. To prevent
damage to the draperies while traveling, the VENETIAN
TYPE BLINDS should be lowered, secured at the
bottom and the slats turned vertically.
Carpet
The carpet can be cleaned with any good commercial
carpet cleaner, or with a detergent and water. BE
CAREFUL NOT TO SOAK THE CARPET WITH WATER.
Vinyl Floor
The vinyl floor in your unit can be cleaned with liquid
floor cleaning solutions recommended for vinyl floors
and warm water.
Counter Area
The counter areas around the sink are of a high-
pressure laminate or Corian and can be cleaned with
soap and water, or you can use a common solvent
on tough spots. Be sure no abrasive cleaner is used,
as there is the possibility it could scratch the surface.
A protective pad should always be placed under hot
utensils. Sanding minor damaged areas can repair
Corian counters. The color of the material is constant
and not just a surface coat.
Vinyl Covering and Interior Ceiling
Damp wiping with mild detergent does routine
cleaning. Using any of the automotive cleaners
designed for vinyl car seats and dashes can perform
more thorough cleaning.
Sinks
The stainless steel galley sink can be cleaned with a
commercial stainless steel cleaner available at most
stores. The lavatory sink is a very dense material called
KARRAN. In the unlikely event of it ever being stained
powdered cleansers such as Ajax/Comet may be
used or even Scotch-Brite pads. The color is constant
through the thickness of the material,
Shower Stall
To clean your fiberglass shower stall unit use warm water
and one of the stronger liquid detergents. Do not use
abrasive cleaners, they may scratch and dull the surface
of your fiberglass unit. Stubborn stains can be removed
with solvents such as turpentine, paintthinner or acetone.
Restore dulled areas by rubbing with an automotive type
liquid cleaner then put the soft slow back into your
fiberglass unit with a light application of liquid wax.
E - 2
INTERIOR
Lounges
To convert the front lounge to a bed first set the armrest
cushions out of the way, lift up on the front of the seat
and pull it out. This will unhinge the sofa so it can be
pushed flat into a bed.
Tables
Folding tables are lifted into a horizontal position and
the legs are folded down to support the table leaf. The
leg assembly can be pulled out and the top unfolded to
extend the table top.
E