Repeating Calibration - Siemens 670 V2 Operating Instructions Manual

Figure 8-6
3. Click on the "Drawing" button.
4. Click on the "Right click" button. The right click tool will be activated.
8.3.3

Repeating calibration

Introduction
If the touch screen does not react as expected when touched, repeat the calibration. To do
this, first activate the 2 point calibration and then calibrate the touch screen.
Procedure
1. Start the touchware settings as described in the last section.
2. Switch to the "Touch settings" tab control. The following dialog will appear:
Panel PC 670 V2/870 V2, Control unit
Operating Instructions, Edition 03/2004, CD Documentation and Drivers
Touch settings tab control
Operating and parametrizing
8.3 Additional drivers and applications
8-11