ASSEMBLING THE MOWER BEFORE FIRST USE
Delivery Checklist
Remove the mower from the packaging and check that
the following items have been supplied correctly. If any
items are missing contact, your local Hayter dealer.
1. Engine Handbook.
4. Ignition Key (412).
3. Charger (412).
6. Warranty Reg Card.
To prevent accidents cut off the long ribbon attached to
the grassbag and discard.
the battery for 14 hours. (Refer to battery charging)
Handlebar
allow the handlebar to pivot.
Hold the engine stop lever in towards the handlebar and
unfold the handlebar to the operating position, before
releasing.
(Codes 412 & 413 only)
Tighten both handlebar knobs to secure in position.
Take care to ensure that the control cables do not
become snagged at the pivot point.
Grassbag Assembly
the frame (1) into the grassbag (2), ensuring that the han-
dle is above the grassbag as shown. A ttach plastic clips
(A), (B), (C) and (D) to the grassbag frame.
Prevent Engine Damage
To prevent engine damage the engine is shipped
the correct grade of oil and petrol before starting the
engine.
Oil Type
oil. Never use additives with recommended oil.
To prolong the life of your engine it is important that
'Maintenance Schedule'.
Check Oil Level
the mower on a level surface, unscrew and remove the
and remove it to check the oil level.
2
1
B
A
D
C
7
The oil level is correct when it is at the full mark on
the dipstick. DO NOT OVERFILL.
Fuel Type
Always use clean, fresh unleaded petrol. Purchase fuel
in quantities that can be used within 30 days. Never mix
oil with petrol. For added engine protection Briggs &
Stratton recommend the use of their fuel additive which
is available from an authorised Briggs & Stratton service
dealer.
Fill to base of neck to allow for fuel expansion. Do not
0.15
Litres