Hardware Setup; Front Panel; Rear Panel - Miditech audiolink pro Owner's Manual

• CD-ROM Drive
• Windows 2000 (SP2), Windows XP (SP1) Home or Pro, Windows Vista

Hardware Setup

Front panel

The front panel of the Audiolink Pro provides the following functions:
1. Channel 1 XLR MIC Input : This XLR balanced connector accepts a MIC level signal for
Channel 1 of the Audiolink Pro. You can turn on the 48V phantom power for your condenser
microphone if required.
2. Channel 1 Level LEDs: These two LEDs show signal present and clipping for Channel 1.You
should adjust the Gain control so that the signal present is as high as possible, but without the Clip
LED coming on.
3. Channel 1 MIC Gain Knob: This control regulates the level of signal for channel 1 Mic input.
4. Channel 2 XLR MIC input : This XLR balanced connector accepts a MIC level signal for
Channel 2 of the Audiolink Pro. You can turn on the 48V phantom power for your condenser
microphone if required.
5. Channel 2 Level LEDs: These two LEDs show signal present and clipping for Channel 1.You
should adjust the Gain control so that the signal present is as high as possible, but without the Clip
LED coming on.
6. Channel 2 MIC Gain Knob: This control regulates the level of signal for channel 1 Mic input.7.
Direct Monitor Output Jack: when this switch is pressed, you can hear the output sound direct
from the analog input. When you turn your software monitor on, remember to turn the direct
monitor off.
8. Headphone Output Jack: This ¼" stereo jack plays back outputs 1 and 2 through the Left and
Right speakers of your headphones.
9. Headphone Level Knob: This controls the level of the Headphone Out
10. Power Indicator: This LED indicator lights when the Audiolink pro is receiving power from
the USB port.

Rear panel

The rear panel of the Audiolink Pro houses features providing the following functions:
1. Output 1 and 2 Jacks: This pair of balanced ¼" jacks provide the output the signal from your
computer and should be connected to a pair of powered speakers, a mixer or a stereo amplifier.
2. Input 1 and 2 Jacks: Using this pair of balanced ¼" jacks you can connect any LINE level
device or instrument, these also provide HI-Z inputs for electric guitars and basses!
3. Phantom Power Switch: Press this switch to the „In" position to provide voltage to
microphones that require phantom power on XLR Mic Inputs 1 and 2.
4. Phantom Power LED:This switch lights when phantom power is switched on.
5. USB Jack: This jack connects the Audiolink pro to your computer, using a USB 1.1 (or higher)
connection.
6.Power connector: for external 9V power supply.
Connection and operating devices:
The product case is printed with all relevant information! There are two XLR Mic sockets and the
adjustment switches for the input level next to them. On the front right side you can find the
headphone out and its level control. On the opposite side there are the ¼" LINE/INSTR. inputs, and
3