Usb Connection; Connecting The Audiolink Pro To Your Computer; Mic And Mic/Instrument Inputs; Line Inputs (Stereo ¼” Jacks) - Miditech audiolink pro Owner's Manual

the LINE outputs. Connect the LINE out sockets with a regular ¼" jack cable to an amplifier. All
outputs, the LINE out and the headphone out, all provide the same mix.

USB Connection

The Audiolink Pro communicates with your computer through a USB port. It is also powered by the
USB connection. Because of this, we recommend that you plug the Audiolink Pro into one of the
built-in USB ports on your computer, not through a keyboard connection or USB hub.
To connect your Audiolink Pro, find an unused USB port on your computer and connect it to the
Audiolink Pro jack with the included USB cable.The computers USB socket will most often be
located on a rear panel and will probably be marked with a symbol looking
something like the one pictured here. When used with Windows XP & Vista, the Audiolink Pro is
class-compliant, making driver installation optional. To start using the Audiolink Pro, you may
simply plug the unit into a USB port . However, choosing to install the driver will allow the
following functions to be added:
Windows XP and Vista – A Device Control Panel and ASIO support with low-latency drivers

Connecting the Audiolink Pro to your computer

Connecting the Audiolink to a computer is very easy! Simply connect your Audiolink Pro with the
included USB cable, to a free USB port on your computer. When the Audiolink Pro is attached the
red POWER LED lights up briefly to signal a good power supply to the Audiolink Pro. The
installation under Windows will then take place automatically, a few seconds after connecting to
your computer-system it will find a "USB Audio Codec" or "USB Audio Device", which can be
used in each application and adjusted in the system control. By using this USB connection your
digitized audio data can now be transferred to your computer!

MIC and MIC/Instrument inputs

Connect your Microphones to input 1 and/or 2, or your electric guitar etc., to the rear panel inputs!
If you use a Microphone, which needs phantom power the phantom power switch is located on the
rear panel of the Audiolink Pro. You can adjust the input levels for MIC/LINE/INSTR. channels 1
and 2 separately with the two Input level controls next to the XLR input sockets.
LINE inputs (stereo ¼" jacks)
Connect your line level device to the two ¼" sockets marked „LINE input" on the rear panel of the
Audiolink Pro. You can connect any devices with a LINE level output, e.g. Tape deck or CD player.
LINE-outputs (stereo ¼" jacks)
Connect your amplifier to these outputs to monitor recordings or sounds from the computer.

Stereo headphone-output

Connect your headphone to this output to monitor recordings or sounds from the computer.

SOFTWARE INSTALLATION

Windows XP/VISTA
Follow these instructions to install the ASIO2ks ASIO drivers on a Windows XP/VISTA computer.
1. First connect the Audiolink Pro to your computer using the supplied USB cable, turn it on.
2. Windows will detect the new USB device and install the USB audio device automatically.
3. Insert the Software/Manual Installation CD into your CD-ROM drive. Find the asio2ks.cpl in the
4