Fujitsu fi-5950 Getting Started page 5

3. Press the "I" side of the main power switch to
turn on the scanner.
■ Connecting the SCSI interface
When using the scanner with a SCSI interface, the fol-
lowing SCSI cable and SCSI card must be purchased.
• SCSI cable
Use a SCSI cable whose connector on the scan-
ner side is the 68-pin high-density shielded-type
and whose connector on the PC side fits the con-
nector of the SCSI card to use.
It is recommended to use a cable of length 1.5 m
or shorter.
• SCSI card
Find the recommended SCSI card information
on the Fujitsu web site (FAQ).
http://www.fujitsu.com/global/support/
computing/peripheral/scanners/scsi/
•
When connecting the SCSI cable, turn
ATTENTION
the scanner off. Be sure to connect the
SCSI cable first, and then turn on the
power of the scanner and PC.
•
In a SCSI daisy chain configuration,
connect the scanner so that it is the ter-
minated device.
1. Insert the SCSI cable into the interface connec-
tor of the scanner until both sides click.
OFF ON
2. Connect the other end of the cable to your PC.
Be careful not to bend the pins of the SCSI
ATTENTION
cable when connecting to the scanner.
3. Set the SCSI ID using the SCSI ID switch on
the back of the scanner.
The SCSI ID is initially set to "5" at the factory.
If the SCSI ID of another SCSI device is set to the
same ID, either change the scanner's SCSI ID or
SCSI ID of the other SCSI device.
ID No.
0 to 7 Can be set as the ID
Works with the factory default value
8, 9
(SCSI ID = 5).
When the scanner is turned on, the SCSI ID set is
enabled.
4. Press the "I" side of the main power switch to
turn on the scanner.
5
Description
OFF ON