Advertisement
Plug the toaster into an appropriate power outlet and switch on power at the outlet. The
•
power socket must be readily accessible so that in an emergency it can be easily
switched off and the toaster unplugged.
Set the browning control to the maximum level (6) and press the on/off button.
•
Let your toaster heat up for approximately four minutes without any bread.
•
NOTE: Due to remnants from the manufacturing process burning off, you may notice a
slight burning smell when first using the toaster. This is no cause for concern. Place the
toaster in a well ventilated area and let it complete a few toasting cycles until no more
odour or smoke is present.
After a short cooling down period, your toaster is now ready for use. The usage
•
instructions start just below. All parts referred to in the instructions are listed on page 4.
Make sure the crumb tray is properly in place before using the toaster. (It is located
•
underneath the heating elements and can be pulled out from the side of the toaster
opposite the controls.)
Make sure that the power cord underneath the appliance is
•
clamped in the respective cable guide: there are two guides for
the cord exit, one for a 120V flat cord and one for a 240V round
cord (as pictured, right).
Place the toaster on an even and heat-resistant surface and
•
connect it to a properly installed wall socket. The LCD panel lights
up and displays the chosen settings (browning level, countdown time, special functions,
etc.).
Insert the bread into the bread slots. The toaster holds two slices.
•
Turn the browning control knob to your desired browning level (1 - 6). The higher the
•
number, the longer the toasting time. (See page 6 for hints on toasting times for different
types of bread.)
Press the raise/lower toast button. The bread will lower into the slots automatically and
•
the toasting process starts. The LCD panel will display the countdown toasting time.
When the required toasting level has been achieved, the toaster switches off
•
automatically. The toast slices will be lifted into their initial position for easy removal.
To interrupt the toasting cycle before automatic cut-off, press the raise/lower
toast button. The toast slices will raise and can be removed.
After several toasting cycles, pull out the crumb tray and clean it. (See the cleaning
•
instructions on page 7.)
If a slice of bread should get stuck during the toasting process, unplug the
appliance and let it cool down completely before trying to remove it. Do not use any sharp
metal objects to do so.
Use this function to reheat bread that was toasted earlier. Simply insert the bread into the bread
slots, press the reheat button and then the raise/lower toast button. The bread will lower and
the reheating process starts. The toaster automatically stops after approximately 24 seconds.
The preset browning level has no influence on the reheat cycle. To cancel the reheat function,
press the reheat and the raise/lower toast button.
To activate the defrost function, start the toaster as described before, but press the defrost
button before choosing your desired browning level, then press the raise/lower toast button.
The bread will lower and the countdown time starts. The defrost cycle stops automatically. The
preset browning level determines the defrost/countdown time.
5
Advertisement
