Subaru 2016 Outback Owner's Manual page 83

Conventional Cruise Control
●
Automatic cancellation by the system
In the following cases, a buzzer sounds a single long beep and the Cruise control function is
automatically canceled (
tions listed below have been eliminated, perform the cruise control set operation again to
reactivate cruise control.
• The select lever was moved to a position other than
The cruise control function can be used again after the lever is returned to the
tion.
• A paddle shift switch was operated during
driving with the lever in the
The cruise control function can be used
again after the shift indicator returns to
• Vehicle speed drops to approximately 20
MPH (30 km/h) or less (due to a steep uphill
grade or some other reason).
• The X-mode is turned on (the X-mode indicator light
- Cruise control can be resumed after the X-mode is turned off.
• Vehicle speed rises to approximately 100 MPH (160 km/h) or more.
• The ABS, Vehicle Dynamics Control or Traction Control functions activate.
• Any door (except the rear gate/trunk) was opened.
• The driver's seatbelt is unfastened.
• The Electronic Parking Brake is engaged (When the brake system warning light is illumi-
nated or flashing).
• When the EyeSight system has a malfunction. ("
Yellow) is turned on.)
• The steering wheel is turned significantly in either direction.
• The grade of the road is steep.
• The Pre-Collision secondary braking has activated.
Do not use Conventional Cruise Control on slippery roads. Doing so may
result in an accident.
82
is displayed on the EyeSight display area.). After the condi-
D
position.
WARNING
D
.
D
.
illuminates).
" (EyeSight Warning indicator:
D
posi-
S01132