Subaru 2016 Outback Owner's Manual page 78

Hide thumbs Also See for 2016 Outback:
Table of Contents

Advertisement

(2) Switch to Conventional Cruise Control.
Press and hold the
seconds or longer to switch from Adaptive Cruise Control to Conventional Cruise
Control. A buzzer sounds 1 short beep.
At this time, the following distance setting indicator on the EyeSight display area of the
multi information display turns off and
To set the ready status:
Conventional Cruise Control can be set when
all of the following conditions are met and
is displayed on the EyeSight display
area.
- All doors (except the rear gate/trunk) are
closed.
- The driver's seatbelt is fastened.
- The electronic parking brake is not
engaged (The brake system warning light
is turned off.).
- The selector lever is in the
and the paddle shift is not operated.
- The brake pedal is not depressed.
- EyeSight operation is not temporarily stopped.
Refer to page 87.
- The road is not on a steep slope.
- The steering wheel has not been turned significantly in either direction.
- The X-mode is not turned on.
- The vehicle speed is between approximately 25 MPH (40 km/h) and 90 MPH (145
km/h).
(3) Control the accelerator pedal to reach the desired speed.
/
(following distance setting) switch for approximately 2
(Conventional Cruise Control) is displayed.
S01992
D
position,
Conventional Cruise Control
S01129
S02975
77

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents