Miele DG 6100 Operating And Installation Instructions page 76

Problem solving guide
Problem
After moving house the
appliance no longer
switches from the heat‐
ing-up phase to the
cooking phase.
During operation an un‐
usually large amount of
steam escapes or
steam escapes from
parts of the steam oven
where it does not usual‐
ly.
A whistling sound is
heard when the appli‐
ance is switched on
again.
The  symbol appears
in the display and an
audible tone may
sound.
The  symbol and a
number between  and
 appear in the display.
 h and  are flash‐
ing.

 and other fault codes
76
Possible cause and remedy
Altitude affects the boiling point of water. If you move
house, the appliance will need to be reset for the new
altitude if this differs from the old one by more than
300 m.
 To adjust the boiling temperature, you need to
descale the appliance (see "Cleaning and care -
Descaling").
The door is not properly closed.
 Close the door.
The door seal is not correctly fitted.
 If necessary, press it in all the way round the door
to make sure it is fitted evenly.
The door seal is damaged, e.g. cracked.
 Call Miele.
When the door is closed, the pressure has to equal‐
ise, which can cause a whistling sound. This is not a
fault.
The water container has not been pushed into the ap‐
pliance properly.
 Remove the water container and push it back in
so that it connects.
There is not enough water in the water container. The
water level must be between the two marks.
 Fill the water container
The appliance needs to be descaled.
 Proceed as described in "Cleaning and care -
Descaling".
Communication fault
 Switch the steam oven off and then back on again
after a few minutes.
 If the same message appears again, call Miele.
Technical fault.
 Switch the appliance off and call Miele.