GE JBP15 Use And Care Manual page 26

ANTI-TIP DEVICE
A
WARNING
All rangescan tip.
Injury could result.
Installthe Anti-tipdevice
packedwith the range.
c See the Installation
Instructions.
STABILITY DEVICEINSTALLATION I NSTRUCTIONS F ORBRACKET ~T NO.342473
Tools needed:
Phillips head screwdriver
1 X" open end or adjustable wrench
The bracket attaches to floor or wall to hold either the
right or left rear leg leveler. If fastening to the floor.
be sure that the screws do not penetrate electrical
wiring or plumbing. If this cannot be determined, use
shorter screws that will not penetrate through flooring.
The bracket is packed inside the oven. Remove and
follow the instructions belokv.
1. Decide whether the bracket will be installed on the
right or left side of the range location,
2. If the bracket side of the range is adjacent to a
cabinet, place the bracket against back wall and
cabinet as shown.
If there is no adjacent cabinet, determine where
the location of the range side (painted outside
panel) will be. Place the bracket with its outside
edge at this location and against the back wall.
a ~
. ~
Outside edge of
bracket to be flush
with left or right side
.\
of range
\
<
Adjacent
cabinet
or final
location y +.,
1
Wall behind range
of range
side panel
>@
Make sure ,>' &&
leg leveler
engages slot
\
3. Determine whether you will anchor the bracket to
the floor or wall. Fasten the bracket securely with
the screws provided, The screws are self-drilling in
wood, plywood, particle and chip board and most
metal framing. If attaching to mtisonryyou can buy
suitable screws and anchors at hardware stores. Use
a masonry drill to drill the required holes.
4. Using the wrench, back out the four leg levelers at
least two turns. See the Installation instructions for
more leveling information before positioning rang(
5. Slide the range into place, Be sure the rear leg
leveler fully engages the slot in the bracket. 1(
the range ctinnot be moved back f~r enough lor
the rear leg leveler to enter the bracket. move the
bracket for\vard as required and attach to the tloor
in the new location.
Wall Plate
Screw must enter wood
or metal
n,
Attachment to wall
26