Hisun HS800 Service Manual page 81

Adjusting the Select Lever Shift Rod
• Neutral (1)
• High (2)
• Low (3)
• Reverse (4)
• Select Lever shift rod (5)
• Gear selector assembly (6)
Warning:
You must completely stop the vehicle
and remove your foot from the
accelerator pedal before shifting to a
different range. Failure to stop the
vehicle before shifting will cause
damage to the transmission.
To adjust the shift rod, make sure the
select lever is in the neutral position.
Loosen the locknuts (1) and turn the rod,
Tighten the locknuts.
Periodic Maintenance
Adjusting the Brake light switch
Check the timing of the brake light.
Note:
The brake light switch is operated by
movement of the brake pedal. The
brake light switch is properly adjusted
when the brake light comes on just
before the braking effect starts.
Hold the main body (1) of the brake light
switch so that it does not rotate and turn
the adjusting nut (2) in direction (a) to
come on sooner or (b) to come on later.
3-16