Troubleshooting - Nikon COOLPIX S6 User Manual

Display
SYSTEM ERROR
PRINTER ERROR
CHECK PRINTER STATUS Printer error.

Troubleshooting

If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon representative. Refer to the page
numbers in the right-most column for more information.
Problem
Camera turns off
without warning
Monitor is blank
No indicators appear
in monitor
Monitor is hard to
read
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the cam-
era may stop functioning. In most cases, this phenomenon is caused by a strong external
static charge. Turn the camera off , remove and replace the batteries, and then turn the
camera on again. In the event of continued malfunction, contact your retailer or Nikon
representative. Note that disconnecting the power source as described above may result
in the loss of any data not recorded to internal memory or the memory card at the time
the problem occurred. Data already recorded will not be aff ected.
96
Problem
Error has occurred in
camera's internal cir-
cuitry.
• Battery is low.
• Camera has turned off automatically to save power.
• Battery is cold.
• Camera is off .
• Battery is exhausted.
• Standby mode: monitor turns on when controls are used.
• Flash lamp blinks red: wait until fl ash has charged.
• USB cable is connected.
• A/V cable is connected.
• Time lapse or interval timer photography in progress: mon-
itor turns off automatically between shots
Hide info is selected for Photo info. Select Show info.
• Monitor has dimmed to save power: monitor brightens
when controls are used.
• Adjust monitor brightness.
• Monitor is dirty: clean monitor.
Solution
Turn camera off , remove and reinsert
batteries, and turn camera on. If error
persists, contact retailer or Nikon rep-
resentative.
Check printer. To resume, highlight
Resume (if available) and press
Solution
14
—
.
14
14
106
14
14
14
20
55, 58
54
36, 77
86
14
86
92