Section 6 − Operation; Controls - Hobart 210 MVP Owner's Manual

6-1. Controls

5
1 Wire Speed Control
Control varies the rate of wire being fed
through the welding gun.
2 Power Switch/Supplementary
Protector
Turns power on and off. Also, this switch
functions as supplementary protector CB1.
CB1 protects unit from overload. If CB1
opens, unit shuts down.
OM-260 274 Page 24
.
A complete Parts List is available at www.HobartWelders.com
SECTION 6 − OPERATION
1
Reset power
protector.
3 Voltage Control
Control varies the voltage level of the
welding arc. The voltage range is 4
(minimum) to 7 (maximum) on 115 VAC
and 1 (minimum) to 7 (maximum) on 230
VAC.
6
.
switch/supplementary
4
Light illuminates if main transformer
overheats.
5
6
When pressed, energizes wire feed motor
and gas valve for shielding gas flow.
2
4
3
250 650-A
Switch must "click" into detent
position. DO NOT switch under load.
Over Temperature Light
Gun Trigger Receptacle
Trigger Switch