Electrical Requirements - General tools BT8010 Setup & Operation Manual

22. MAKE SURE THE TOOL is properly
grounded. If equipped with a 3-prong
plug, it should be used with a threepole
receptacle. Never remove the third prong.
23. DO NOT USE THIS dust collector for
any purpose other than its intended use.
If used for other purposes,GENERAL
INTERNATIONAL disclaims any real or
implied warranty and holds itself harmless
for any injury,which may result from that
use.
24. IMPORTANT NOTICE: SOUND LEVEL-
the sound level of this machine is rated
at approximately 80 dB during operation.
Make sure that adequate hearing
protection is used and that the overall
sound level within the working environment
is taken into consideration.

ELECTRICAL REQUIREMENTS

1. BEFORE CONNECTING THE MACHINE
to the power source, verify that the voltage
of your power supply corresponds with
the voltage specified on the motor I.D.
nameplate. A power source with greater
voltage than needed can result in serious
injury to the user as well as damage to the
machine. If in doubt, contact a qualified
electrician before connecting to the power
source.
2. THIS TOOL IS FOR indoor use only. Do
not expose to rain or use in wet or damp
locations.
GROUNDING INSTRUCTIONS
In the event of an electrical malfunction or
short circuit, grounding reduces the risk of
electric shock. The motor of this machine is
wired for 120 V single phase operation and
is equipped with a 3-conductor cord and a
3-prong grounding plug to fit a grounded type
receptacle B. Do not remove the 3rd prong
(grounding pin) to make it fit into an old 2-hole
wall socket or extension cord. If an adaptor
plug is used C, it must be attached to the
metal screw of the receptacle.
®
14102811
7