General tools BT8010 Setup & Operation Manual page 11

ASSEMBLY
WARNING! Serious personal injury could
occur if you connect the machine to the
power source before you have completed
the setup process. Do not hook up the
machine to a power source until instructed
to do so.
1. TAKE THE IMPELLER / SEPARATOR
assembly (D).
2. REMOVE THE NUTS AND attach the
vertical supports (L) to the bolts where
indicated (fig 3).
3. RE-FASTEN THE NUTS THAT were
removed in 2 above (fig.5).
4. INSTALL THE CROSS BRACE (H) using
the 4 short carriage bolts (M) and nuts (N)
(fig 6).
!
14102811
11