Cleaning Or Replacing The Collector Bag - General tools BT8010 Setup & Operation Manual

further help with your dust collector contact
your General International distributor or our
®
Technical Service Department at 1-888-949-
1161.
● All bearings are sealed and permanently
lubricated. No further lubrication is needed.
● Periodically inspect all hardware, fittings
and fasteners that may have loosened due
to vibration - retighten as needed.
● Keep the outside of the unit clean and wipe
off excessive dust or dirt with a dry rag.
● Clean the filter bag on a regular basis and
replace as needed.
● Periodically inspect inside all pipes,
fittings, hoses, blast gates, and connectors
for accumulated dust build-up or other
obstructions, and clean as needed.
Remove sections and vacuum or manually
remove debris as needed.
● Check and if necessary replace all
damaged parts or components.
● Do not operate with a damaged canister
filter - replace damaged filter immediately.
● Periodically inspect the power cord and
plug for damage. If necessary, replace the
power cord and plug at the first signs of
visible damage.
● Use only recommended parts and
accessories. The use of parts or
accessories NOT recommended by
GENERAL INTERNATIONAL may
®
result in a risk of injury or damage to the
machine.
CLEANING OR REPLACING THE
COLLECTOR BAG
NOTE: Depending on your needs, shop
situation and local regulations, collections
bags can be emptied and re-used or
disposed of (with their contents) and
replaced with a new bag.
1. Turn off and unplug the machine.
14