Table of Contents
Advertisement
Dodge Sprinter Passenger Van
1
1
1
2
Fig. 14
2
Fig. 15
2
3
Fig. 16
ATTENTION
Route red power wire through access channel
that runs under floor mat to the drivers seat.
– (1) Access Channel to Drivers Seat
– (2) Red Power Wire to Fuse Panel
ATTENTION
Locate fuse panel and butt splice positive wire
to the fused side of fuse 15. (25 amp fuse)
– (1) Heater Power Wire (Red)
– (2) Fused Side of Fuse 15
ATTENTION
Check your wiring! Ensure that all connections
have been done in accordance with the wiring
diagrams located in the back of this book.
Sensitive electronic controls can be damaged if
wired incorrectly!
CAUTION
Torque all mounting bolts evenly. Do not over-
tighten mounting fasteners! Mounting plate
distortion may occur resulting in fan motor
failure. Ensure the heater base and gasket
covers the entire hole.
ATTENTION
Mount heater to bracket using provided
hardware. Mount Heater/Bracket Assembly to
vehicle using 4 mounting bolts. Insert two
sheet metal screws in forward holes.
– (1) Foam Seal Under Heater Bracket
– (2) Heater Bracket Mounting Bolt
– (3) Location for Sheet Metal Screws
13
Advertisement
Table of Contents
