Advertisement
OPERATING
INSTRUCTIONS
Airflow
direction
control
i
f
L
.......
Rang,
.......
p
Vertical
louver
• Adjust the air flow direction properly otherwise it
might cause discomfort or cause uneven room
temperatures.
• Adjust the horizontal/vertical
louver using the remote
controller. For some models, the vertical louver can
only be adjusted manually.
To set the horizontal/vertical
air flow direction
• Perform this function while the unit is in operation.
• Use the remote controller to adjust the air flow direction.
The vertical/horizontal
louver adjusts
6 degrees in angle
for each press.
Please refer to the "REMOTE
CONTROLLER
OPERATION
MANUAl"
for details.
• For some models, the vertical louver can only be adjusted
manually. Move the deflector rod manually to adjust the air
flow in the direction you prefer.
IMPORTANT:Do
not put your fingers into the panel of
blower and suction side .The high-speed
fan may
cause injury.
Range
CAUTION
• Do not operate the air conditioner
for long periods with
the air flow direction set downward
in the cooling or
dehumidifying
mode. Otherwise,
condensation
may
accumulate
on the surface of the horizontal louver
causing moisture to drop on to the floor or on furnishings.
• Do not move the horizontal louver manually unless it is
necessary. Always use the remote controller.
• When the air conditioner
is started immediately
after it
was stopped, the horizontal
louver might not move for
approximately
10 seconds.
• Open angle of the horizontal
louver should not be set
too low as COOLING
or HEATING performance
may
be impaired due to a highly
restricted air flow area
• Do not operate unit with the horizontal louver in
theclosed
position.
• When the air conditioner
is connected
to power (initial
power), the horizontal louver may generate a sound for
10 seconds, this is a normal.
]4
Advertisement
