Table of Contents
Advertisement
Determine Cable Length
Measure from center of control handle with
remote control in mounting position, along
intended cable route to engine centerline at
transom height as illustrated by dotted lines in
diagram. Add 40 in. (1.0 m) to the measurement.
This dimension is the required cable length.
Evinrude/Johnson Genuine Parts outboard con-
trol cables are available in one-foot increments
from 5 ft. to 20 ft. lengths and two-foot incre-
ments from 20 ft. to 50 ft. lengths. Use cables
that are equal to your calculated length, or are
the next longer available length.
IMPORTANT: Route cables with fewest number
of bends. Bends must never be less than 6 in.
(15 cm) radius.
Remote Control Configuration
The remote control lever can be positioned on
either side of remote control, and the trim/tilt
switch can be oriented to face the port or
starboard side of remote control.
1
Starboard Side Mount
1. Port side trim/tilt switch (standard configuration)
2. Starboard side trim/tilt switch
1
004884
Port Side Mount
1. Port side trim/tilt switch
2. Starboard side trim/tilt switch
IMPORTANT: Determine the required control
handle orientation prior to installing remote con-
trol cables.
2
004862
2
004863
7 of 24
Hide quick links:
Advertisement
Table of Contents
