Trim/Tilt Switch Wire Routing - BRP 5006181 Installation Instructions Manual

Trim/Tilt Switch Wire Routing

Refer to Remote
Diagrams. Note wire positions and routings.
CAUTION
To prevent trim tilt switch wiring from
being damaged, route wires carefully and
provide adequate slack in wiring. Refer to
Remote Control Configuration Diagrams.
Remove control lever cover and note wire posi-
tion and routing and position of wiring shield.
Route wire based on diagram for your specific
control lever configuration. The standard config-
uration is shown below (starboard side mount
with port side trim/tilt switch).
1
1. Cover
2. Wire routing
3. Shield
Route trim/tilt switch wires based on diagram for
your specific control lever configuration. Use the
trim/tilt wire retainer in all configurations. Route
wire through the correct cutout of control housing
cover. Refer to Remote Control Configuration
Diagrams.
1
Starboard Mount Wire Routing
1. Retainer, trim/tilt wire
IMPORTANT: Remote control cables must be
installed to check routing of tilt/trim wiring. Refer
to Install Remote Control Cables.
Control Configuration
004879
004918
1. Cover, trim/tilt wire
1
2
1. Wire cutout, control housing cover
2. Joint, control lever
3
Torque screws to 36 in. lbs. (4 N·m). Install
remote control lever joint. Wire shield must be in
position as shown. Solid side of shield must be
down.
1
1. Screws (2)
2. Shield
1
004920
2
004929
004919
2
1
004928
13 of 24