Install Remote Control Cables - BRP 5006181 Installation Instructions Manual

Position lever on remote control joint. Align
splines of lever with splines of joint. Neutral lock
lever must align with neutral lock plate. Secure
lever with screw and washer. Torque screw to 7
ft. lbs. (10 N·m).
Align wire and shield to prevent rubbing before
installing control lever cover.
1. Shield, solid side down
IMPORTANT: Trim/tilt wire must be routed as
shown in diagrams. Refer to Remote Control
Configuration Diagrams.
14 of 24

Install Remote Control Cables

Remove two screws and back cover from remote
control housing.
004887
Use Triple-Guard
mechanisms, trunnion pockets, and remote
control cables.
1
0049306
Always use new cotter pins and bend both
sides of cotter pin as shown to prevent
interference with remote control housing
or possible dislodging of cotter pin from
mounitng pin.
Install shift cable and flat washer on to shift pin
and secure with new cotter pin. Bend cotter pin
as shown.
1. Shift cable
®
grease to lubricate all moving
WARNING
004885, 004889
004867
004910
1