Install Remote Control In Boat; Electrical Connections - BRP 5006181 Installation Instructions Manual

Install Remote Control in Boat

Hold remote control(s) in selected position. Re-
fer to specific outboard installation instruc-
tions for information related to connecting
remote controls to outboard. Mark three
mounting hole locations on mounting surface.
Refer to profile drawing and use drill template if
needed.
Drill three 1/4 in. (6 mm) holes.
1
1. Mounting holes, standard configuration
Fasten control box in position with mounting
hardware provided. Install using three each of
screws, spacers, washers, lock washers, and
nuts. Tighten mounting screws to 7 ft. lbs. (10
N·m).
IMPORTANT: After remote control is installed,
check that at least three threads of the mounting
screws are extended beyond the nut. Be sure re-
mote control assembly is secure and does not
move during operation.
16 of 24

Electrical Connections

Install trim and tilt wiring into electrical connector.
Position wiring terminals in connector housing as
indicated:
• Terminal for green/white wire in position "A"
• Terminal for blue/white wire in position "B"
• Terminal for red/white wire in position "C"
Insert lock, wedge after terminals are positioned
in connector.
2
1
1. Electrical connector
2. Lock, wedge
004900
1
1. Lock, wedge
IMPORTANT: Apply a light coat of Electrical
Grease™ onto the electrical connector seals.
Push connectors together until latched.
Fasten warning horn bracket to mounting stud of
gauge, or tie strap it to wiring harness. Carefully
route wiring and connect two-pin position horn
connector to two-socket horn connector of
ignition harness. Connect six-pin key switch
harness connector to six-socket connector of
ignition harness.
004897
1
1. Horn connector
2. Key switch harness connector
1
004901
004903
2
004902