Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AZZA PT-5IH
Summary of Contents for AZZA PT-5IH
- Page 1 PT-5IH ( VER. 1.x ) SYSTEM BOARD OPERATION MANUAL...
-
Page 2: Table Of Contents
PT-5IH TABLE OF CONTENTS SYSTEM BOARD TABLE OF CONTENTS Chapter & Section Page INTRODUCTION 1.1 SYSTEM OVERVIEW 1.2 FEATURES SPECIFICATIONS SYSTEM BOARD LAYOUT 3.1 5IH (VER. 1.x) HARDWARE SETUP 4.1 UNPACKING 4.2 HARDWARE CONFIGURATION 4.2.1 DRAM INSTALLATION 4.2.2 L2 CACHE MEMORY INSTALLATION 4.2.3 CONNECTORS... - Page 3 PT-5IH SYSTEM BOARD TRADEMARKS All trademarks used in this manual are the property of their respective owners. NOTE The "LOAD SETUP DEFAULTS" function loads the default settings directly from BIOS default table, these default settings are the best-case values that should optimize system performance.
-
Page 4: Introduction
1. INTRODUCTION SYSTEM OVERVIEW The PT-5IH Pentium PCI Local Bus system board is designed based on the Intel 82430HX PCIset system chipset and Winbond (or SMC, UMC) I/O chipset, which built-in two channels PIO and Bus Master Enhanced PCI IDE port, one Floppy Disk control port, two high speed Serial ports (UARTs) and one multimode Parallel prot and also supports IR and USB ports. -
Page 5: Specifications
PT-5IH SPECIFICATIONS SYSTEM BOARD 2. SPECIFICATIONS Intel : Pentium processor and OverDrive processor (P54C/P54CS/P54CT/P55C/P55CT) 75/90/100/120/133/150/166 MHz and 180/200 MHz. (ideally) Cyrix : 6x86-P120+(100MHz) / P133+(110MHz) / P150+(120MHz) / P166+(133MHz). AMD : 5 86-P75( )/ P75( )/ P90( )/ P90( )/ P100(... - Page 6 PT-5IH SPECIFICATIONS SYSTEM BOARD Super I/O Ports 1. Two high speed NS16C550 compatible serial prots (UARTs). 2. One parallel port, supports SPP/EPP/ECP mode. 3. One Floppy Disk Control port. IR Port (option) One HPSIR and ASKIR compatible IR transmission connector (5-pin).
-
Page 7: System Board Layout
SYSTEM BOARD LAYOUT SYSTEM BOARD 3. SYSTEM BOARD LAYOUT 3.1 PT-5IH Ver. 1.x Explanation : All connectors, jumpers and components which marks by a black point on the corner means the pin-1 side of the connector, jumper and component. PS/2... -
Page 8: Hardware Setup
4.2.1 DRAM INSTALLATION The PT-5IH system board will support two banks main memory (bank0 and bank 1) on board, (using four 72- Pin SIMM socket, SIMM 1 - 4), each bank could be single or double sided. With the use of 1MBx36(32)-S, 2MBx36(32)-D, 4MBx36(32)-S or 8MBx36(32)-D and 16MBx36(32)-S SIMM modules, 8MB up to 256 MB of local memory can be attained. - Page 9 PT-5IH HARDWARE SETUP SYSTEM BOARD The following table provides all possible DRAM memory combination. Total Bank 0 Bank 1 Total Bank 0 Bank 1 Size SIMM1, SIMM2 SIMM3, SIMM4 Size SIMM1, SIMM2 SIMM3, SIMM4 8 MB 1MBx36(32)-S Empty 64 MB...
-
Page 10: L2 Cache Memory Installation
SYSTEM BOARD 4.2.2 L2 CACHE MEMORY INSTALLATION The PT-5IH system board will support one or two bank(s) direct-mapped second level cache and provides either 256KB or 512KB cache memory using synchronous pipeline-burst SRAMs. (Note that this system board does not support asynchronous or burst SRAMs for the cache memory) Both Write Back and Write Through cache update policy are supported. -
Page 11: Connectors
PT-5IH HARDWARE SETUP SYSTEM BOARD 4.2.3 CONNECTORS A connector is two or more pins that are used make connections to the system standard accessories (such as power, mouse, printer,...etc.) The following is a list of connectors on board, as well as descriptions of each individual connector. - Page 12 PT-5IH HARDWARE SETUP SYSTEM BOARD (F) CN5 IR (Infrared Rays) transmission connector Pin # Assignment Pin # Assignment Pin # Assignment +5V DC IR Receive IR Transmit No Connection Ground (G) CN6 COM B (Serial Port 2) connector COM1/2/3/4, selected by BIOS setup, using IRQ3 or 4...
- Page 13 PT-5IH HARDWARE SETUP SYSTEM BOARD (P) RS Reset Button connector Pin # Assignment Pin1&2 Function Reset Control Open No action Ground Short Reset (Q) HL IDE HDD LED connector Pin # Assignment Pullup (+5V DC) Signal Pin (R) SS External SMI button connector...
-
Page 14: Jumpers
4.2.4 JUMPERS A jumper is two, three or more pins which may or may not be covered by a plastic connector plug (mini- jumper). A jumper is used to select different system options. Please make sure all jumpers at correct position before this system board used. - Page 15 (B) JP11-JP16, JP19 CPU operating voltage selection Note : (1). For the detailed CPU-VCC requirement, please inquire of your CPU supplier. (2). In PT-5IH VER.. 1.2 & VER. 1.3 , the JP19 is inexistent, you could skip it. CPU VCC...
-
Page 16: Award Bios Setup
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5. AWARD BIOS SETUP 5.1 GETTING STARTED When the system is first powered on or reset, the BIOS will enter the Power-On Self Test routines ( POST : Display a copyright message on the screen followed by a diagnostics and initialization procedure.) (If an EGA or VGA card is installed, the copyright message of the video card maybe displayed on the screen first.) The... -
Page 17: Main Menu
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.2 MAIN MENU ROM PCI / ISA BIOS (2A59FXXX) CMOS SETUP UTILITY AWARD SOFTWARE, INC. STANDARD CMOS SETUP SUPERVISOR PASSWORD BIOS FEATURES SETUP USER PASSWORD CHIPSET FEATURES SETUP IDE HDD AUTO DETECTION POWER MANAGEMENT SETUP... -
Page 18: Standard Cmos Setup
PT-5IH AWARD BIOS SETUP SYSTEM BOARD The following pages will show the simulate screens of CMOS SETUP, each figure contains the setup items and the default settings of them. Below each figure may or may not be contained a lists of function description for commonly used settings. -
Page 19: Bios Features Setup
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.5 BIOS FEATURES SETUP ROM PCI / ISA BIOS (2A59FXXX) BIOS FEATURES SETUP AWARD SOFTWARE, INC. Virus Warning : Disabled Video BIOS Shadow : Enabled CPU Internal Cache : Enabled C8000-CBFFF Shadow : Disabled... -
Page 20: Chipset Features Setup
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.6 CHIPSET FEATURES SETUP ROM PCI / ISA BIOS (2A59FXXX) CHIPSET FEATURES SETUP AWARD SOFTWARE, INC. Auto Configuration : Enabled DRAM ECC/PARITY Select : Parity DRAM Timing : 70 ns Memory Parity/ECC Check : Disable... -
Page 21: Power Management Setup
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.7 POWER MANAGEMENT SETUP ROM PCI / ISA BIOS (2A59FXXX) POWER MANAGEMENT SETUP AWARD SOFTWARE, INC. Power Management : User Define ** Power Down & Resume Events ** PM Control by APM : Yes... -
Page 22: Pnp/Pci Configuration
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.8 PNP/PCI CONFIGURATION ROM PCI / ISA BIOS (2A59FXXX) PNP/PCI CONFIGURATION AWARD SOFTWARE, INC. Resources Controlled By : Auto PCI IRQ Actived By : Level Reset Configuration Data : Disabled PCI IDE IRQ Map To... - Page 23 PT-5IH AWARD BIOS SETUP SYSTEM BOARD IRQ# / DMA# assigned to : Legacy : The system BIOS will skip never assign this specified IRQ/DMA resource to PCI or ISA PnP devices. PCI/ISA : All items set to this value will make the specified IRQ/DMA have a chance to be assigned to PCI or ISA PnP devices.
-
Page 24: Integrated Peripherals
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.9 INTEGRATED PERIPHERALS ROM PCI / ISA BIOS (2A59FXXX) INTEGRATED PERIPHERALS AWARD SOFTWARE, INC. IDE HDD Block Mode : Enabled PCI Slot IDE 2nd Channel : Enabled On-Chip Primary PCI IDE : Enabled On-Chip Secondary PCI IDE... -
Page 25: Load Setup Defaults
PT-5IH AWARD BIOS SETUP SYSTEM BOARD 5.10 LOAD SETUP DEFAULTS This option loads the SETUP default values from BIOS default table. By pressing "Enter" key, while "LOAD SETUP DEFAULTS" is highlighted, then presses "Y" and "Enter" key. the SETUP default values will be loaded. - Page 26 Printed in Taiwan Edition : 2.0...
Need help?
Do you have a question about the PT-5IH and is the answer not in the manual?
Questions and answers