AZZA PT-5IVL Operation Manual
  1. Manuals
  2. Brands
  3. AZZA Manuals
  4. Motherboard
  5. PT-5IVL
  6. Operation manual

AZZA PT-5IVL Operation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

PT-5IVL
SYSTEM BOARD
( VER. 1.x )
OPERATION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PT-5IVL and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for AZZA PT-5IVL

Summary of Contents for AZZA PT-5IVL

  • Page 1 PT-5IVL SYSTEM BOARD ( VER. 1.x ) OPERATION MANUAL...

  • Page 2: Table Of Contents

    SYSTEM BOARD TABLE OF CONTENTS Chapter & Section Page INTRODUCTION SYSTEM OVERVIEW FEATURES SPECIFICATIONS SYSTEM BOARD LAYOUT PT-5IVL VER. 1.2 HARDWARE SETUP UNPACKING HARDWARE CONFIGURATION 4.2.1 DRAM INSTALLATION 4.2.2 L2 CACHE MEMORY INSTALLATION 4.2.3 CONNECTORS 4.2.4 JUMPERS AWARD BIOS SETUP...
  • Page 3 PT-5IVL SYSTEM BOARD TRADEMARKS All trademarks used in this manual are the property of their respective owners. NOTE The "LOAD SETUP DEFAULTS" function loads the default settings directly from BIOS default table, these default settings are the best-case values that should optimize system performance and increase system stability .

  • Page 4: Introduction

    1. INTRODUCTION SYSTEM OVERVIEW The PT-5IVL Pentium PCI Local Bus system board is designed based on the Intel 82430VX PCIset system chipset and Winbond I/O chipset, which built-in two channel Enhanced PIO and Bus Master PCI IDE ports, one Floppy Disk Control port, two high speed Serial ports (UARTs) and one multimode Parallel port and also supports IR port.

  • Page 5: Specifications

    PT-5IVL SPECIFICATIONS SYSTEM BOARD 2. SPECIFICATIONS □ Intel : Pentium processor and OverDrive processor (P54C/P54CS/P54CTB/P55C) 75/ 90/ 100/ 120/ 133/ 150/ 166 MHz and 180/ 200 MHz (ideally). Cyrix : 6x86-P120+(100MHz)/ P133+(110MHz)/ P150+(120MHz)/ P166+(133MHz), M2 series. AMD : 5k86-P75(SSA/5-66)/ P75(SSA/5-75)/ P90(SSA/5-83)/ P90(SSA/5-90)/...
  • Page 6 PT-5IVL SPECIFICATIONS SYSTEM BOARD Super I/O Ports □ 1. Two high speed NS16C550 compatible serial ports (UARTs). 2. One parallel port, supports SPP/EPP/ECP mode. 3. One Floppy Disk Control port. IR Port (option) □ One HPSIR and ASKIR compatible IR transmission connector (5-pin).

  • Page 7: System Board Layout

    SYSTEM BOARD LAYOUT SYSTEM BOARD 3. SYSTEM BOARD LAYOUT 3.1 PT-5IVL VER. 1.2 Explanation : All connectors, jumpers and components which marks by a black point on the corner means the pin-1 side of the connector, jumper and component. PS/2...

  • Page 8: Hardware Setup

    4.2.1 DRAM INSTALLATION The PT-5IVL system board will support two banks main memory (bank 0 and bank 1) on board (using four 72- Pin SIMM socket, SIMM 1-4), each bank could be single-sided or double-sided, 8MB up to 128 MB of local memory can be attained.

  • Page 9: L2 Cache Memory Installation

    SYSTEM BOARD 4.2.2 L2 CACHE MEMORY INSTALLATION The PT-5IVL system board will support one bank direct-mapped second level cache, and provides either 256KB or 512KB cache memory, using synchronous pipeline-burst SRAMs. (Note that this system board does not support asynchronous or burst SRAMs for the L2 cache memory) Both Write Back and Write Through cache update policy are supported.
  • Page 10 PT-5IVL HARDWARE SETUP SYSTEM BOARD (F) CN5 COM B (Serial Port 2) connector COM1/2/3/4, selected by BIOS setup, using IRQ3 or 4 Pin # Assignment Pin # Assignment ○ ○ DCD (Data Carrier Detect) (Received Data) ○ ○ (Transmit Data) DTR (Data Terminal Ready) ○...
  • Page 11 PT-5IVL HARDWARE SETUP SYSTEM BOARD (J) CN9 Floppy Disk Control Port connector (Using IRQ6, DMA channel 2) (K) CN10 Pipeline-burst SRAM (COAST) module slot (L) CN11 IDE 2 connector (Secondary IDE Port, using MIRQ0) (M) CN12 IDE 1 connector (Primary IDE Port, using IRQ14)

  • Page 12: Jumpers

    PT-5IVL HARDWARE SETUP SYSTEM BOARD 4.2.4 JUMPERS A jumper is two, three or more pins which may or may not be covered by a plastic connector plug (mini- jumper). A jumper is used to select different system options. Please make sure all jumpers at correct position before this system board used.
  • Page 13 PT-5IVL HARDWARE SETUP SYSTEM BOARD (B) JP4-JP10 CPU operating voltage selection CPU VCC CORE JP10 Remark voltage voltage + 3.3 V + 3.3 V open open short + 3.4 V + 3.4 V open short open + 3.5 V + 3.5 V...

  • Page 14: Award Bios Setup

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5. AWARD BIOS SETUP 5.1 GETTING STARTED When the system is first powered on or reset, the BIOS will enter the Power-On Self Test routines ( POST : Display a copyright message on the screen followed by a diagnostics and initialization procedure.) (If an EGA or VGA card is installed, the copyright message of the video card maybe displayed on the screen first.) The...

  • Page 15: Main Menu

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.2 MAIN MENU ROM PCI / ISA BIOS (2A59GXXX) CMOS SETUP UTILITY AWARD SOFTWARE, INC. STANDARD CMOS SETUP SUPERVISOR PASSWORD BIOS FEATURES SETUP USER PASSWORD CHIPSET FEATURES SETUP IDE HDD AUTO DETECTION POWER MANAGEMENT SETUP...

  • Page 16: Standard Cmos Setup

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD The following pages will show the simulate screens of CMOS SETUP, each figure contains the setup items and the default settings of them. Below each figure may be or may not be contained a lists of function description for commonly used settings.

  • Page 17: Bios Features Setup

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.5 BIOS FEATURES SETUP ROM PCI / ISA BIOS (2A59GXXX) BIOS FEATURES SETUP AWARD SOFTWARE, INC. Virus Warning Disabled Video BIOS Shadow : Enabled CPU Internal Cache : Enabled C8000-CBFFF Shadow : Disabled External Cache...

  • Page 18: Chipset Features Setup

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.6 CHIPSET FEATURES SETUP ROM PCI / ISA BIOS (2A59GXXX) CHIPSET FEATURES SETUP AWARD SOFTWARE, INC. Auto Configuration Enabled DRAM Timing : 70 ns DRAM RAS# Precharge Time : 4 DRAM R/W Leadoff Timing...

  • Page 19: Power Management Setup

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.7 POWER MANAGEMENT SETUP ROM PCI / ISA BIOS (2A59GXXX) POWER MANAGEMENT SETUP AWARD SOFTWARE, INC. Power Management User Define ** Power Down & Resume Events ** PM Control by APM : Yes IRQ 3 (COM 2)

  • Page 20: Pnp/Pci Configuration (For Normal Bios)

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.8 PNP/PCI CONFIGURATION (For Normal BIOS) ROM PCI / ISA BIOS (2A59GXXX) PNP/PCI CONFIGURATION AWARD SOFTWARE, INC. 1st Available IRQ 2nd Available IRQ : 11 3rd Available IRQ 4th Available IRQ : 12 PCI IRQ Actived By...

  • Page 21: Pnp/Pci Configuration (For Plug & Play Bios)

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD : The BIOS will not assign any IRQs even if PCI IDE card is found. Because some IDE cards connect the IRQ 14 and 15 directly from ISA slot thru a card. (This card is called Legacy Header) 5.9 PNP/PCI CONFIGURATION...
  • Page 22 PT-5IVL AWARD BIOS SETUP SYSTEM BOARD Reset Configuration Data : Disabled : The system BIOS will do nothing. Enabled : The system BIOS will clear/reset the ESCD during "POST". After clearing the ESCD, the system BIOS will then change this item's value back to "Disable", otherwise, the ESCD will become useless.

  • Page 23: Integrated Peripherals

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.10 INTEGRATED PERIPHERALS ROM PCI / ISA BIOS (2A59GXXX) INTEGRATED PERIPHERALS AWARD SOFTWARE, INC. IDE HDD Block Mode Enabled IDE Primary Master PIO : Auto IDE Primary Slave PIO : Auto IDE Secondary Master PIO...

  • Page 24: Load Setup Defaults

    PT-5IVL AWARD BIOS SETUP SYSTEM BOARD 5.11 LOAD SETUP DEFAULTS This option loads the SETUP default values from BIOS default table. By pressing "Enter" key, while "LOAD SETUP DEFAULTS" is highlighted, then presses "Y" and "Enter" key. the SETUP default values will be loaded.
  • Page 25 Printed in Taiwan Edition : 1.0...

Table of Contents