Connection And Setup - Onkyo PR-SC886 Service Manual

QQ
3 7 63 1515 0
FIRMWARE UPDATE -2
Preparation for Update (Main microprocessor)
Hardware and Software
1. Personal computer(PC) with Windows XP or 2000
2. Flashwriter jig: 0JFLASH and 0JFLASHEX for Main
3. Writing soft: "flasta_exe.zip" and Manual: "Flash Writer M16 Manual.pdf"
4. Program & ID: Download the latest ".mot" and ".id" files for TX-SR876/TX-SA876/DTR-8.9/DHC-9.9/PR-SC886 and

Connection and Setup

1. While the target unit is powered off, connect 0JFLASH and 0JFLASHEX to RS232 port of the PC.
2. Connect the FFC of the jig to the connector slot on the rear panel of TX-SR876/TX-SA876/DTR-8.9/DHC-9.9/PR-SC886 .
3. Power on the unit.
TE
L 13942296513
PC
(Personal computer)
Main Microprocessor Update Procedure
1. Start "FlashSta.exe" and update the unit referring to "Flash Writer M16 Manual.pdf".
MCU Type is M16C/80 M32.
2. After "Program and Read Check" are finished, click "Exit" button to end "FlastSta.exe".
3. Turn off the main power switch or pull the power cord off the wall socket.
Pay attention that pushing [ON/STANDBY] button to power off is not perfect.
4. Remove the jig from the unit and power on the unit again. Confirm the new version number.
www
.
http://www.xiaoyu163.com
Download and unzip "flasta_exe.zip" to extract "FlashSta.exe" etc. in advance.
store in the same folder as "FlashSta.exe."
Flashwriter Jig
0JFLASHEX
FFC
0JFLASH
RS232
It takes about 15 minutes.
x ao
y
i
http://www.xiaoyu163.com
8
Q Q
3 6 7 1 3
No line cut
u163
.
TX-SR876/SA876
2 9 9 4 2 8
Connector slot
1 5 0 5 8 2 9 9 4
TX-SR876 Rear Panel
m
co
9 9
2 8 9 9