Installing The Batteries In The Remote Control - DGTEC DG-HDPVR5009 User Manual

ASSEMBLY AND PARTS LIST

1.6 Installing the batteries in the remote control

1. Press down on the retaining catch on the lid of the battery recess on the remote
control and slide downward to remove the lid.
2. Insert two AAA batteries into the recess.
3. Replace the lid over the recess and gently push down on the lid and slide upward
until it snaps firmly into place.
Caution
1. Keep batteries out of the reach of children.
2. Do not attempt to recharge, short-circuit, disassemble, heat or throw the batteries
into the fire.
3. Always replace both batteries at the same time. Never mix new and old batteries
or batteries of a different type.
4. If you don't intend to use the remote control for an extended period, remove the
batteries to prevent possible leakage and corrosion.
5. Do not drop, apply shock or step on the remote control.
6. Do not spill water on the remote control.
Note: If the STB does not respond when operating the remote control from a
close range, you will need to replace the batteries.
Using the Remote Control
1. To use the remote control, point it towards the front of the PVR.
2. The remote control has a range of up to 7 metres from the PVR at an angle of up
to 60 degrees.
3. The remote control will not operate if its path to the sensor on the front panel of the
PVR is blocked.
Note: Sunlight or very bright light will decrease the sensitivity of the remote
control.
8