Remote Control Unit - Denon AVR-1804 Operating Instructions Manual

ENGLISH
Auto Tuner Presets
• Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels A1 to 8, B1
to 8, C1 to 8, D1 to 8 and E1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to
tune in the station, then preset it using the manual "Preset memory" operation.
1
Use the CURSOR button to select "Yes".
"Search" flashes on the screen and searching
begins.
"Completed" appears once searching is completed.
The display automatically switches to screen.
25 PRESET <YES
2
Press the ENTER or
the beginning.
After setting up the system
1
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the
settings again unless other components or speakers are connected to or the speaker layout is changed.
• On-screen display signals
Signals input to the AVR-1804
VIDEO signal input jack
S-video signal input jack
(yellow)
1 E
2 C
3 E
4 C
(C: Signal E: No signal)
16
(down) button if you want to start the settings over from
On-screen display signal output
Video signal output to
Video signal output to S-
VIDEO MONITOR OUT jack
Video MONITOR OUT jack
(yellow)
E C
E C
C C
C E
(C: On-screen signals output E: On-screen signals not output)
11

REMOTE CONTROL UNIT

Operating DENON audio components
• Turn on the power of the different components before operating them.
1
Set mode switch 1 to "AUDIO".
2
Set mode switch 2 to the position for the
component to be operated. (CD, CDR/MD or
Tape deck)
3
Operate the audio component.
• For details, refer to the component's operating instructions.
While this remote control is compatible with a wide range of infrared controlled components, some
models of components may not be operated with this remote control.
1. CD player (CD) and CD recorder and MD
recorder (CDR/MD) system buttons
, : Manual search
6 7
(forward and reverse)
: Stop
2
1 : Play
, : Auto search (cue)
8 9
: Pause
3
DISC SKIP + : Switch discs
(for CD changers only)
3. Tuner system buttons
C
C
C
C
NOTE:
• TUNER can be operated when the switch is at "AUDIO" position.
3
1 2
3
2. Tape deck (TAPE) system buttons
: Rewind
6
: Fast-forward
7
2 : Stop
: Forward play
1
: Reverse play
0
A/B : Switch between decks A and B
SHIFT : Switch preset channel range
CHANNEL +, – : Preset channel up/down
TUNING +, – : Frequency up/down
BAND : Switch between the AM and FM
bands
MODE : Switch between auto and mono
MEMORY : Preset memory