Table of Contents
Advertisement
5
7.2 DISASSEMBLY
Note 1: Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
Note 2: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Note 3: For the performing the diagnosis shown below, the following jigs for service are required.
• GGF1529 : Emerqency tray ejection rod.
• GGF1533 : BB Extension board
• GGD1437 : BB Extension cable
Diagnosis of PCB's
1
Bonnet Case and Tray Panel
1
Remove the Bonnet Case by removing the eight screws.
2
Press the
STANDBY/ON button to turn on the power.
3
Press the 0 OPEN/CLOSE button to open the Tray.
4
Remove the Tray Panel.
5
Press the
STANDBY/ON button to turn off the power.
6
Pull out the Power cord.
4
3
2
Tray Panel
How to open the Tray when the power cannot be on
1
Open the Door.
2
Insert GGF1529 into bore as shown in the following figure.
If the Tray pops out a little, fully pull it out by hand.
Tray open
2
5
6
Tray
5
3
Tray
1
Door
6
7
BDP-HD1
7
8
A
B
C
D
E
F
79
8
Advertisement
Table of Contents
