Table of Contents
Advertisement
Attaching/Detaching the stand and wall mounting
ATTACHING THE STAND
1) Insert the stand (PART A) into the stand neck (PART B)
2) Use the assembly screws to fasten the stand base securely.
Make sure that the screws are securely tightened.
DETACHING THE STAND
Detaching the Stand
1) Remove the screws highlighted
Wall mounting the TV
This television requires a VESA 400 x 200 wall mount, or equivalent.
1) Remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
For optimum viewing, if wall mounting the TV higher than eye level, the TV should be
tilted downwards so that the TV's screen is 'face on'. See fi g 1 and 2
Important – If wall mounting this TV, only use the screws already provided in the wall mounting holes.
Using other screws which are longer could cause irreparable damage to internal parts.
Max length is 12mm
2) Although there are no live parts exposed when removing
the stand, (in the event of wall mounting the TV) for aesthetic
purposes, included in the accessory pack is a cover plate which can
be clipped into the underside of the TV.
IMPORTANT - Before drilling any holes in the wall
ensure you are not drilling where there could be
any electric wires, water or gas pipes.
fi g 1
INCORRECT
Viewing angle
CORRECT
fi g 2
Viewing angle
TV
9
9
Advertisement
Table of Contents
