Advertisement
Attach vacuum hose and tools
1.
Line up the tabs on the baseof the Twist'n
Snaphosewith the correspondingnotches
on the hosecollar as shown.
2.
3.
Turnthe Twist'n Snaphoseto the left
to lock the hoseinto place.
Connectthe curved hosewand to the hose.
Graspingthe curved hosewand,slide the
endof the curved hosewand ontothe hose
wand base.Snapthe hoseinto the hoseclip.
NOTE: T hevacuumwill notoperateeffectively
unlessthe curvedhosewand is firmly attached.
4.
Slidethe extensionwand and crevicetool
togetherinto the storage clip.
5.
Slidethe dusting brush/upholsterytool into
the storageclip.
6.
Attachthe TurboBrush by snappingit onto
the top cap of the uppertank.
Power switch
Thepowerswitchis locatedjust belowthe
handleon the front of the vacuum. P ushthe
rockerswitch"ON" (I) to vacuum, a nd "OFF"(0)
whencleaningis complete.
/Twist'n
SnapHose
, CAUTION:
Beforeusing your vacuum,
make sure that the dirt
containeris in the locked
positionand that all filters
(pre-motor and post-motor)
are in place. Do not operate
yourvacuum without these
filters.
NOTICE:
For above floor cleaning, the floor
brush will continue to rotate but
is raised above floor, To prevent
carpet damage, do not lean on
the vacuum or let the powerfoot
tilt forward,
/ CAUTION:
To avoid personalinjury
and to prevent the cleaner
from falling when cleaning
stairs, always place it at
the bottom of the stairs.
6
www,bissell,com
800,237,7691
Advertisement
