OPERATING
THE
MOWER
Slopes
To prevent engine damage do not use the mower on slopes greater
than 20 degrees.
B
Height of Cut
To adjust the height of cut: Grip the lever and pull sideways to dis-
engage it from the locking notch, then push forwards to lower or pull
backwards to raise the height of cut. Finally release the lever at the
required position and ensure it locks firmly into one of the eight set-
ting notches.
Always select a height of cut to suit operating conditions. Aim to pre-
vent engine overloading and blockages by avoiding low cuts in long
305113
grass conditions. Be prepared to make two cuts when the grass is long.
CS284
1.17