Adjusting The Basic Position Of The Foot Brake Lever - KTM 2011 690 SMC EU Owner's Manual

BRAKES

Adjusting the basic position of the foot brake lever

11.7
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to over-
heating. Adjust free travel on foot brake lever according to specifications.
x
–
Remove screws
–
To adjust the basic position of the foot brake lever individually, loosen nut
screw accordingly.

Info
The range of adjustment is limited. The screw must be screwed into the footrest
bracket by at least four turns.
–
Position foot brake cylinder
Hold screws
Guideline
Nut, foot brake cylinder screw
–
Check the free travel of the foot brake lever. (
–
Tighten nut
600639-10
on foot brake cylinder

so that the foot brake lever has the necessary free travel.

in place and tighten the nuts.

.

.

M6 10 Nm (7.4 lbf ft)
p. 81)
82
and turn
