How To Install Water Line - Daewoo FRAQ19DC Series Operating Instructions Manual

How to install Water Line

(Dispenser models only)
1. The water pressure should be 2.0~12.5 kgf/cm² (1.96
~12.26 Bar) or more to run the automatic icemaker.
Check your tap water pressure; if a cup of 180cc is
full within 10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not
close to any hot surfaces.
3. The water filter only filters water; it does not eliminate
any bacteria or microbes.
4. If the water pressure is not sufficient to run the
icemaker, call the local plumber to get an additional
water pressure pump.
5. The filter life depends on the amount of use. We
recommend you to replace the filter at least once
every 6 months.
When attaching the filter, place it for easy access
(removing & replacing)
6. After installation of refrigerator and water line system,
select [WATER] on your control panel and press it for
2~3 minutes to supply water into the water tank and
dispense water.
7. Change to ice mode and press leel to start function
working, ice will take a few days to fully form.
8. Use plumbers thread sealing tape on every
connection of pipes/tubes to ensure there is no water
leaks.
9. The water tube should be connected to the cold water
line.
■
WATER SUPPLY KIT
Check the parts below for installing water supply.
Some other necessary parts are available at your
local service agents.
Connector
Fastener x 3
Filter box
8
Holder Screw x 4
Water tube A/B
Installation Procedure
models only)
1. Join Connector to the tap water line
Figure A
Connector A
Water tube
Figure B
Connector A
Water tube
Place the rubber packing inside the tap connector
and screw onto the water tap.
2. Get ready to install the Water Filter
1) Measure an approximate distance between the filter
and the water tube and cut the tube off filter vertically.
2) Connect the tubes to the filter as the figure shows.
Tap side
Water tube
Filter
Refrigerator
Leave a sufficient distance when cutting the
tubes.
3. Remove any substances in the filter.
1) Open the main tap water valve and check if water
comes out of the water tube.
2) Check if the water valve is open in case water does
not come out.
3) Leave the valve open until clean water is coming out.
Initial water may contain some substances out of
filter (manufacturing process).
(Dispenser
Tap
Connector B
Rubber packing
Tap
Rubber packing
A right angle