How To Install Water Line - Daewoo FRS-T24FA Service Manual

Side by side refrigerator
Hide thumbs Also See for FRS-T24FA:
Table of Contents

Advertisement

INSTALLATION GUIDE

2. How to install water line

How to install Water Line
1. The water pressure should be 3kgf/cm
automatic icemaker.
Checkup your tap water pressure ; if a cup of 180cc is full
within 10 seconds, the pressure is OK.
2. When installing the water tubes, ensure they are not colse to
any hot surfaces.
3. The water filter only filters water ; it does not eliminate any
bacteria or microbes.
4. If the water pressure is not so high to run the icemaker, call the
local plumber to get an additional water pressure pump.
5. The filter life depends on the amount of use. We recommend
you replace the filter at least once every 6months.
When attaching the filter, place it for easy access (removing
& replacing)
6. After installation of refrigerator and water line system, select
[WATER] on your control panel and press it for 2~3 minutes to
supply water into the water tank and dispense water.
7. Use sealing tape to every connection of pipes/tubes to ensure
there is no water leak.
8. The water tube should be connected to the cold water line.
Installation Procedure
1. Join Connector to the tap water line
1) First lock the main tap water valve.
Check if connector B and C has its own rubber packing ring in it.
2) Join Connector-C to the water tap, then Connector -B to
connector -C with a wrench or spanner.
3) Insert water pipe into Connector-B and join Connector-A with a
wrench or spanner.
4) In case Connector-C does not fit water tap join Connector-B
directly to the tap.(See Figure B.)
If no connector fits water tap, call your local service.
5) Unlock main tap water valve, open tap water and check if any
water leaks on each joins.
Achtung
Achtung
Place the rubber washer inside the tap connector and
screw onto the water tap.
2. Get ready to install the Water Filter
1) Measure an approximate distance between the filter and the
Water Tube and cut the tube off filter vertically.
2) Connect the tubes to the filter as the figure shows.
Achtung
Achtung
Leave a sufficient distance when cutting the tubes.
or more to run the
2
47
WATER SUPPY KIT
Check the parts below for installing water supply.
Some other necessary parts are available at your local
service agents.
Connector A,B,C
(3014454510)
(7112401211)
(3010541600)
<Figure A>
<Figure B>
(3012020700)
3011202000
(A:3019503200
B:3019503300)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Frs-t24da

Table of Contents