Installation Procedures; Cooler Assembly - MasterCool MCP59 Installation And Operating Manual

NOTE: BEFORE INSTALLING UNIT, TAKE A MOMENT TO RECORD THE SERIAL NUMBER AND WRITE IT ON THE
MANUAL COVER IN THE SPACE PROVIDED
INSTALLATION PROCEDURES
WARNING: Do not connect electrical power to the unit until the installation is completed.
The MasterCool MCP59 cooler can be installed in a sash‐style or a slider‐ style window.
Alternatively, this unit is approved for in‐wall installations.
In all installations, the following clearances are required:
Width: 22"; Height: 22"
NOTE: Ensure the location selected for installing the unit is strong enough to support the unit and will accept
the mounting hardware. The operating weight of the cooler is 93 pounds.
NOTE: A minimum of two people is required for installation.
Parts Included:

Cooler Unit

Mounting brackets (4)

Accordion spacers (2) Hardware kit
Tools & Materials Required:

Drill (power or cordless)

Assorted drill bits (for drilling pilot holes for mounting hardware)

Adjustable Wrench

Phillips Head Screwdriver

Silicone or all‐weather caulk for sealing infill panel to window frame

Length of ¼" copper or plastic tubing

Sillcock valve

Bubble level

Spacer material (as required)
Cooler Assembly
Remove unit from box. Verify that all parts are included.
1. Remove all packing materials.
CALL 1‐800‐643‐8341 IF YOU FIND PARTS MISSING OR HAVE ANY QUESTIONS
2. With the unit in an upright position, remove 4 screws holding the back media guard, and separate the front
and back sections. Pull the fan assembly forward (about 6") until it is fully engaged with the mating part
and secure in place using the 12 supplied screws. Verify that assembly is secure to prevent vibration
between the two sections
3. PULL BACK GUARD
.
4" clearance above the exterior cabinet is needed for maintenance.
.
OPEN UNIT UP
AWAY FROM UNIT
1. REMOVE 4 SCREWS FROM
BACK MEDIA GUARD
2. PUSH UP ON BACK GUARD
SECURE FAN HOUSING
4
EXTEND HOUSING AND
ATTACH IT TO
COOLER BODY FRONT
WITH 12 SCREWS