Download Print this page

Mocet IG7600 Quick Installation Manual

Smart telephone system

Hide thumbs Also See for IG7600:

See also: Administration Manual , Quick Installation Manual

IG7600

Smart Telephone System

Quick Installation Guide

Ver11140311

Table of Contents

Need help?

Do you have a question about the IG7600 and is the answer not in the manual?

Page 2 IG7600 Smart Telephone System Quick Installation Guide Powering up 1. Plug the IG7600 in and allow it to power up without connecting any telephones. When the power LED stops flashing the IG7600 will be fully powered up and operational. 2. Use an Ethernet cable to connect your Personal Computer, Laptop or Desktop running Windows XP, Vista or Windows7/8, to the LAN port of the IG7600.
Page 3 Installation Components Getting Started The IG7600 can be installed several different ways. Installing the IG7600 these ways as below will allow the system to synchronize the time and date from the Internet and if wanted connect low cost Internet SIP Telephone lines.
Page 4 Network Configuration Choices Connecting to an Existing Network: Connect the WAN port of your IG7600 to your existing network, leaving the LAN port disconnected after using it for the initial installation programming. (You need to enable UPnP server setting in router or setup router’s DMZ to IG7600.)
Page 5 Obtain a static IP address from your Internet Service Provider (ISP) or use dynamic IP address with Dynamic DNS. (Please check IG7600 Administration Guide for the further information). Connect the WAN port of your IG7600 to the ISP Modem and use the LAN port to connect all of your phones and computers.