Other Features - commercial cool WPAC08R series User Manual

SET UP & USE
WATER DRAINAGE
• During dehumidifying modes,
remove the drain plug from the
back of the unit, install the drain
connector (5/8" universal female
mender) with 3/4" hose (not
included). For the models without
drain connector, just attach the drain
hose to the hole. Place the open end
of the hose directly over the drain
area in your basement floor.
• When the water level of the bottom
tray reaches a predetermined
level, the unit beeps 8 times, the
digital display area shows "P1."
At this time, the air conditioning/
dehumidification process will
immediately stop. However, the fan
motor will continue to operate (this
is normal).
Carefully move the unit to a drain
location, remove the bottom drain
plug and let the water drain away.
Restart the machine until the "P1"
symbol disappears. If the error
repeats, call for service.
NOTE: · Be sure to reinstall the bottom
drain plug before using the unit.
Remove the drain plug
Continuous drain hose
Fig.23
Fig.24
Fig.25

OTHER FEATURES

AUTO RESTART
(Applicable to some models)
If the unit breaks off unexpectedly due
to the power cut, it will restart with the
previous function setting automatically
when the power resumes.
WAIT 3 MINUTES BEFORE
RESUMING OPERATION
Fig.23
After the unit has stopped, it can not
be restarted operation in the first 3
minutes. This is to protect the unit.
Operation will automatically restart
after 3 minutes.
Fig.24
SWING OPERATION
ADJUST THE AIR FLOW DIRECTION
AUTOMATICALLY
• When operation is ON, the louver
opens fully. Use the SWING button
on the remote control to stop the
Fig.25
louver at the desired angle.
• The louver move up to an angle of
6° for each press until it moves to
a position which would affect the
cooling or heating effect of the air
conditioner, it would automatically
change the swing direction.
• If keep pressing the SWING button
more than 2 seconds, the AUTO
SWING feature is activated.
Page 17