Exhaust Hose Installation - commercial cool WPAC08R series User Manual

SET UP & USE
DOUBLE-HUNG SASH/SLIDING CASEMENT WINDOW
INSTALLATION
1. Cut the foam seal (adhesive type)
to the proper length and attach it to
the window stool.
2. Attach the window slider kit to the
window stool. Adjust the length of
the window slider kit according to
the width of window, shorten the
adjustable window kit if the width of
window is less than 26.5". Open the
window sash and place the window
slider kit on the window stool.
3. Cut the foam seal (adhesive type)
to the power length and attach it on
the top of the window.
4. Close the window sash securely
against the window slider kit.
5. Secure the window slider kit to the
window stool.
6. Cut the foam seal to an appropriate
length and seal the open gap
between the top window sash and
outer window sash.
NOTE: · Window Slider Kit can reach a minimum of 26.5" and a maximum of 48.0"

EXHAUST HOSE INSTALLATION

The exhaust hose and adaptor must be installed or removed in accordance with
the usage mode:
COOL, AUTO : Install
FAN, DEHUMIDIFY, HEAT (ELECTRICAL) : Remove
1. Install the window exhaust adaptor onto
the exhaust hose as shown.
2. Place the exhaust hose over against the
air outlet opening hook and firmly push
and rotate counter clockwise to lock it in
place. Fit the opposite end of the exhaust
adaptor into the window slider kit for
quick installation.
NOTE: · The exhaust hose can be compressed or
extended moderately, but it is desirable to
keep the length to minimum. Also make
sure that the hose does not have any sharp
bends.
Foam
Seal
Window Stool
Window
Slider Kit
Window
Slider Kit
Foam
Seal
Push in
26.5"~48.0"
Window
Slider Kit
Window
Slider Kit
Exhaust hose
Hook
Page 11
Foam
Seal
Foam
Seal