Cleaning & Care - commercial cool WPAC08R series User Manual

CLEANING AND CARE
DANGER
1. Be sure to unplug the unit
before cleaning or servicing.
2. Do not use gasoline, thinner or
other chemicals to clean the
unit.
3. Do not wash the unit directly
under a tap or using a hose. It
may cause electrical danger.
4. If the power cord is damaged,
it should be repaired by an
authorized technician.
AIR FILTER
Clean the air filter at least once every
two weeks to keep fan operation at its
optimum efficiency. This unit has two
filter. Grasp the upper filter tab, slide
the filter out. Remove the lower filter
by loosening the screw, taking down
the air inlet grille, then removing the air
filter.
WPAC08R WPAC14R
**
WPAC10R /RH
** **
WPAC12R
**
/RH
**
Screw x1 Screw x3
Page 18
Upper Filter
Slide the air filter
out
Lower Filter
Remove the screws
(according to
model) and take
the air inlet grille
down
**
Remove the air
filter out from the
grille
CLEANING
Wash the air filter by immersing
it gently in warm water (about
104°F/40°C) with a neutral detergent.
Rinse and dry the filter.
MOUNTING
Insert the upper air filter after cleaning,
attach the lower air filter on the air inlet
grille, then install the grille by using the
screw.
UNIT ENCLOSURE
Use a lint-free cloth soaked with neutral
detergent to clean the unit enclosure.
Finished by a dry clean cloth.
EXTENDED UNIT STORAGE
• Remove the rubber plug at the back of
the unit and attach a hose to drain outlet.
Remove the plug from the bottom drain
outlet, all the water in the bottom tray
would drain out. (see picture on pg.15)
Place the open end of the hose directly
over the drain area in your basement
floor.
• Keep the appliance running on FAN
mode for half a day in a warm room to
dry the appliance inside and prevent
mold.
• Stop the appliance and unplug it,
wrapped the cord and bundle it with
the tape. Remove the batteries from the
remote controller.
• Clean the air filter and reinstall it.
• Unscrew the exhaust hose to the right or
left and pull out to remove, keep it safety,
and cover the window(wall) hole with an
adaptor cap (not included).