Power Cord Operation - commercial cool WPAC08R series User Manual

SAFETY INFORMATION

POWER CORD OPERATION

The power supply cord contains a current device that senses damage to the power
cord. To test your supply cord follow these steps:
1. Plug in the Air Conditioner.
2. The power supply cord head has two buttons, a TEST button and a RESET
button. Press the TEST button and notice a click as the RESET button pops out.
3. Press the RESET button. Once again notice a click as the button engages.
4. The power supply cord will now supply electricity to the unit.
NOTE:
• Do not use this device to turn the unit on or off.
• Always make sure the reset button is pushed in
for correct operation
• The power supply cord must be replaced if
it fails to reset when either the test button is
pushed, or it cannot be reset.
• If power supply cord is damaged, it cannot be
repaired.
• It must be replaced by one obtained from the
product manufacturer.
OPERATING CONDITION
The air conditioner must be operated within the temperature range indicated below:
MODE
COOL
DRY
HEAT
(ELECTRICAL HEAT TYPE)
NOTE: · Unit performance may be affected when in use outside of these operating temperatures.
Page 8
ROOM TEMPERATURE
62°F (17°C) ~ 95°F (35°C)
55°F (13°C) ~ 95°F (35°C)
≤ 88°F/30°C
RESET
TEST